I have a variation on the common problem with getting the P265 to control the volume on my pioneer TV.
I go through the setup instructions:
- Press OK and 0 for 5 seconds
- enter 290
- Press channel up until it turns off my TV
- Test Volume +-, mute, input, EVERYTHING WORKS FINE
- Press OK to set the programming - red light blinks and goes out just like it is supposed to
BUT, once I push that final OK, the remote no longer controls the Volume. IT still works for on/off, mute, input, but NOT for volume. Somehowe volume was working before I pushed the final OK to finish the programming, but once I push OK the remote forgets how to control the volume (but still works of on/off, mute, etc).
Any ideas?
thanks,
m